Move the definition of the off64_t using int64_t bellow the include stdint.h, which is actually defining it.
Without change wrong order is breaking the build on RHEL7/8/9.
The code that handles nwipe.conf now checks
an existing nwipe.conf for the correct default
groups. This allows future additions to the
nwipe.conf file to be added to an existing nwipe.conf
file. This makes the code more robust.
The code that handles creation of groups, settings and
values has been made into a function so any future additions
to nwipe.conf can be added with a single call to this function.
i.e
nwipe_conf_populate( "Default_Wipe.Method", "PRNG" );
The code can now handle creation of groups to a arbitrary
depth of four levels, however currently we only use a
group depth of 1.
i.e
CCC :
{
XXX :
{
YYY :
{
ZZZ :
{
};
TTT :
{
};
};
};
};
Fix_warning_directive_output_may_be_truncated
Fixed the following warning:
create_pdf.c:795:18: warning: ‘/nwipe_report_’ directive output may be truncated writing 14 bytes into a region of size between 1 and 4096 [-Wformat-truncation=]
Fixed the following warning:
create_pdf.c:795:18: warning: ‘/nwipe_report_’ directive
output may be truncated writing 14 bytes into a region of
size between 1 and 4096 [-Wformat-truncation=]
The message that logs which directory the nwipe PDF certificate is being saved, was being printed multiple times in the middle of the erasure summary table.
This was corrected so that it only prints once at the end of the table
The message that displays where the nwipe PDF certificate
is being saved was being printed multiple times in the
middle of the erasure summary table.
This was corrected so that it only prints once at the end
of the table.
Due to significant delays in obtaining drive temperature
from some drives especially SAS which was causing a noticeable
freeze of a second or two or more in the GUI wipe status
screen, being made worse the more drives that were being
simultaneously wiped.
The temperature update code was separated from the GUI code
by placing the temperature update in it's own thread.
The HPA message alternating with the drive model serial
number made reading the serial number quite a challenge
and made the display far too messy looking when displaying
20+ drives or even 10+ drives with differing HPA statuses.
Removed, alternating appearance.
Reduced size of message.
Placed after temperature, before drive model/serial in display.
Previously smart data was completely located
on page 2 in two columns using a variable width font.
This had two issues. The font size had to be very small
to fit on the page which made it difficult to read
and variable width fonts were used because the smart
attribute table took up too much width when all the data
was displayed in two newspaper type columns. This made the
smart attribute table look messy.
This patch now displays the smart data over page two and three
in mono spaced font and with a larger font size so it's easier
to read and the columns with the smart attribute table are now
aligned correctly.
In terms of the code, I placed the header and footer creation
code in it's own function as this is called multiple times
and will make it easier to add additional information pages
in the future.
Added new options in GUI config menu to display preview of
organisation, customer, date/time at startup prior to drive
selection. This preview is disabled as default but can be
enabled in the config menu.
The purpose of the preview is to allow the user to check &
update as required the organisation details, customer &
current date/time so that the details provided on the PDF
certificate/report are correct.
